<br><font size=2 face="sans-serif">Hi dear,</font>
<br><font size=2 face="sans-serif">If I understand, you're trying to change a varbind (Cisco SNMP variable) of your cisco router through the SNMP command. So, in this case you can make a SNMPWALK command to know all varbinds (OID) and after you'll change the specific varbind using the SNMPSET command as you want. </font>
<br><font size=2 face="sans-serif">Oh, First of all you need to enable the SNMP protocol in your Cisco router.</font>
<br>
<br><font size=2 face="sans-serif">Best regards,<br>
<br>
Cleber De Conto Pettinelli<br>
Pre-Sales Engineer<br>
Phone: +55 51 3358 3130<br>
Mobile: +55 51 9256 4879<br>
SIP: cleber@voip.digitel.com.br<br>
Skype: cleberpettinelli<br>
MSN: cleberpettinelli@hotmail.com<br>
E-mail: cleber@digitel.com.br<br>
Web: http://www.digitel.com.br<br>
DIGITEL S/A INDÚSTRIA ELETRÔNICA</font>
<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td>
<td><font size=1 face="sans-serif"><b>Brent Clark <bclark@eccotours.co.za></b></font>
<br><font size=1 face="sans-serif">Sent by: lartc-bounces@mailman.ds9a.nl</font>
<p><font size=1 face="sans-serif">04/10/2006 07:18</font>
<br>
<td><font size=1 face="Arial"> </font>
<br><font size=1 face="sans-serif"> To: lartc@mailman.ds9a.nl</font>
<br><font size=1 face="sans-serif"> cc: </font>
<br><font size=1 face="sans-serif"> Subject: [LARTC] SNMP to detect that a Cisco router....</font></table>
<br>
<br>
<br><font size=2 face="Courier New">Hey all<br>
<br>
Would anyone know how you use SNMP to detect that a Cisco router is using an alternative (redundant) interface and then change the routing settings on your firewall.<br>
<br>
Kind Regards<br>
Brent Clark<br>
<br>
_______________________________________________<br>
LARTC mailing list<br>
LARTC@mailman.ds9a.nl<br>
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc<br>
</font>
<br>
<br>