[LARTC] Re: htb traffic shaping problem

[Bugzilla-Redirect]

Yes, the output is below:
eth0      Link encap:Ethernet  HWaddr 00:11:09:2A:A6:F6
           inet addr:10.0.0.50  Bcast:10.0.0.255  Mask:255.255.255.0
           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
           RX packets:4244867 errors:0 dropped:0 overruns:0 frame:0
           TX packets:1306632 errors:0 dropped:0 overruns:0 carrier:0
           collisions:0 txqueuelen:1000
           RX bytes:3898905509 (3.6 GiB)  TX bytes:1756030081 (1.6 GiB)
           Interrupt:19

And from ethtool:
Settings for eth0:
         Supported ports: [ MII ]
         Supported link modes:   10baseT/Half 10baseT/Full
                                 100baseT/Half 100baseT/Full
                                 1000baseT/Full
         Supports auto-negotiation: Yes
         Advertised link modes:  10baseT/Half 10baseT/Full
                                 100baseT/Half 100baseT/Full
                                 1000baseT/Full
         Advertised auto-negotiation: Yes
         Speed: 1000Mb/s
         Duplex: Full
         Port: MII
         PHYAD: 1
         Transceiver: external
         Auto-negotiation: on
         Supports Wake-on: g
         Wake-on: d
         Link detected: yes

Thanks.
-Ryan Power

At 04:32 PM 9/14/2006, you wrote:
>Hi,
>
>could you check the mtu set on eth0 with an ifconfig?
>I tried my own setup and it works fine...
>
>
>Regards,
>
>Eric Janz
>Departamento de Sistemas
>Grupo Barceló Viajes