[LARTC] Advanced Routing and Secondary ip address in eth0

[gypsy]

Leonardo Borda wrote:
> 
> Hello,
> 
>     I have configured advanced routing with success using three (03)
> network adapters ( ETH0,  ETH1 and ETH2).
>     Now I have to configure an addittion range in the same Interface
> ETH0 ( another internet ip range address ), so I would like to have TWO
> different ranges at the same ETHERNET CARD ( in this case ETH0 ) AND
> having advanced routing running it.
>     I Did the same configurations as I already done it before and it is
> not working. When testing through the secondary ip address the packets
> get out from the wrong default gateway, however testing from primary
> range I am able to route.
> 
>     Is it possible to do advanced routing having in the same Interface
> TWO different ip range address?
> 
>     Somebody had done this somewhere?
> 
> Thanks in advanced
> 
> --
> Atenciosamente,
> 
> Leonardo Borda

Leonardo,

Have you Yahooed/googled this?  IIRC, I came across several pages
describing your desired setup while trying to decide how to deal with 3
NICs and two different IPS (therefore separate nets on each NIC).  Again
IIRC, I rejected these because they were not the correct solution for
me.

Sorry I can't be more help, but I do think your solution is "out there".
--
gypsy